Push the "RESERVE" button, select the suitable pre-wash program
Push the "START/PAUSE" button
5 Close the lid
6 Finish washing
After reserving , indicator light of
is off
lights of reserve and surplus time are
on work .during reserve program , press the
if change program or cancel pre-wash program ,you must turn off the power and select it again.
selected program
reserve button ,reserve state can be shown.
18 hours later, finish wash
After Finishing wash
alarm automatically
Insure running the "reserve" program
RESERVE
After finishing wash
it'll alarm automatically
As the top lid opened ,the Washer will automatically give an alarm
and stop running , exclusively during supplying water and rinsing.
START
PAUSE
Using process
After turning on the power , pre-wash program will be selected automatically as initial state .if you wish the
washer would have finished work in preset time, push reserve button and select pre-wash program .
Refer to the reserve for the selection.(See to page11)
"
"
"
"
Time list of each program (minute)
Program water level Soak (min) Wash (min) Rinse (min/time) Spin (min) Total time (min)
Normal
Jeans
Gentle
Speedy
Rinse twice with stored
water, about 5
Rinse twice with stored
water ,about 5
Rinse once with stored
water, about 2
Rinse once with stored
water, about 1.5
1~10
1~10
1~10
2~4
About 30
About 30
About 15
About 12
About 15
About 3
About 2.5
About 7
About 7
About 2
About 2.5
About 47
About 50
About 17
About 10
* Total time: including the normal water filling time, drain time, excluding the soak time.
* Spin time: the time from intermittent running to finishing
* When running "Jeans
program and selecting soak , first soak for about 25 minutes, pre-wash for about 10 minutes, then
soak for about 5 minutes, then do washing, rinsing and spinning. (Remark : there is intermittent agitating wash during soak )
*The finishing time may be influenced by the water inlet pressure and water level.
Using process