20
Steps for Installation
Installing Your Washer:
Caution:
If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your Washer is
properly installed it is recommended that it be installed by a certified
installer.
1. Insert a new flat washer into each end of the water inlet hoses.
Firmly put the washers in the coupling.
Note:
2. Connect the hot and cold water inlet hoses to the hot and
cold water faucet.
English
Select a suitable location for the washer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
Any floor unevenness should be corrected with the leveling legs located on the
bottom corners of the washer. The washer must be placed at room temperature.
You must not place washer where the temperature is at below freezing.
Read installation instructions carefully before installation.
You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause damage to the valve.
