Haier KGG5201-A1, Инструкция по эксплуатации

Страница: 23 / 24

CLEANING AND MAINTENANCE
Replacement of the oven light
bulb
In order to avoid the possibility of
an electric shock ensure that the
appliance is switched off before
replacing the bulb .
 Set all control knobs to the position
“
● ” and disconnect the mains plug.
 Unscrew and wash the lamp cover
and then wipe it dry.
 Unscrew the light bulb from the
socket, replace the bulb with a new
one – a high temperature bulb (300
℃ )
with the following parameters:
-voltage 120 V
-power 25 W
-thread G 9.
 Screw the bulb in, making sure it is
properly inserted into the ceramic
socket.
 Screw in the lamp cover.
Oven light bulb
Door removal
In order to obtain easier access to the oven
chamber for cleaning, it is possible
to
remove the door, to do this, tilt the safety
catch part of the hinge upwards, close the
door lightly, lift and pull it out towards you,
in order to fit the door back on to the
cooker, do the inverse. When fitting,
ensure that the notch of the hinge is
correctly placed on the protrusion of the
hinge holder. After the door is fitted to the
oven, the safety catch should be carefully
lowered down again, if the safety catch is
not set it may cause damage to the hinge
when closing the door.
Door removal
GB
44
CLEANING AND MAINTENANCE
Removal of the internal glass
panel
Unscrew and unfasten the plastic latch that
is in the corner at the top of the door. Next
take out the glass from the second
blocking mechanism and remove. After
cleaning, insert and block the glass panel,
and screw in the blocking mechanism.
Removal of the internal glass panel
Regular inspections
Besides keeping the cooker clean, you
should:
 Carry out periodic inspections of the
control elements and cooking units of
the cooker, after the guarantee has
expired you should have a technical
inspection of the cooker carried out at
a service centre at le ast once every
two years.
 Fix any operational faults.
 Carry out periodical maintenance of
the cooking units of the cooker.
All repairs and regulatory activities should
be carried out by the appropriate service
centre or by an appropriately authorized
fitter.
GB
Caution !
45