Haier HWM95-261NZP, Инструкция по эксплуатации, Страница: 6 / 19

Connection of water inlet pipe
Smoothly placed the washing machine can reduce the noise
and vibration, please adjust the washing machine to be smooth
before use it.
.
Loosen the locked nut with a wrench.
.
.
.
.
Adjust the washing machine to be smooth by adjusting the height of
the foot
(
Totally 5 feet
).
)
.
Tighten the locked nut by a wrench along the rotating direction after
adjusting the feet to be smooth.
The distance between washing machine and wall is at least 5cm.
The maximum allowable tilted angle of washing machine‘s
supportable surface is 20 degree.
Please use the new water inlet pipe attached to you, the old can not be reused.
a. Choose the right faucet
b.Take off the water inlet pipe joint
The front end length of faucet is more than
10mm, and the outlet side is smooth, in order
to avoid leaking.
①
Press and hold the lower end of the locking lever.
②
Press down the slider and take off the water inlet
pipe joint.
c. Install the water inlet pipe joint
①
Uncover the tag.
②
Adjust the nut and make it to expose
3-4 threads.
③
Loosen the four screws on the water inlet pipe joint
until the joint can be put on the faucet.
④
If the water inlet pipe joint can’t be put on the faucet,
remove the bushing.
⑤
Tighten the four screws evenly, and then tighten the
nut until the water isn’t penetrated.
Installation and adjustment