>10mm
Connection between the water inlet hose jointer and the water faucet
Water faucet,not suitable
Install the water inlet hose
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.
Outlet end surface
Water faucet,suitable
About less than 2mm after twisting
Figure 3
Bushing
About 4mm before twisting
2. Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet.
See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen
the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth,
otherwise it may leak water. See to Figure 3.)
1.
Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
Screw
remark: Before installation, the threading is 4mmabove the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut. See to figure 6.
Figure 6
Sign plate
4.Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Figure 2
Screw nut
Screw knife
3.
Fasten the four screws evenly. See to Figure 4.
water inlet hose jointer
Figure 5
Slider
Figure 1
water inlet hose
Figure 4
Lock level
Confirm the water faucet
POW
ER
ON/O
FF
PROGRAM
START
PAUSE
AIR DR
Y
BLANKET
SAVE
SILK
STANDARD
COTTON
1HOUR
2HOURS
"Start/pause" button
After the power is switched on, press it to
start the machine
During working, push it to pause.
During pause, push this button to restart
and go on working
"Program" button
Standard Common washing
Following full-auto program is available
Program
Application
Blanket
Silk
Save
Washing for the normal laundries
in short time
Washing for coverlet, bigger ,heavy
thickness laundries
Washing for silk textiles
"Power" button
Push the "power" button to switch on the power.
Under power-on mode, push it to switch off the power.
Push the "power" button to switch on the power. If the
"start/pause" button is not pushed, the machine will
switch off the power automatically after 5 minutes.
"AIR-
"
DRY button
Push the
D
button ,then the
D
is on,
D
The purpose is drying the
inner tub and the outer tub, which can avoid
growing mildew on the outer tub and the inner
tub.
"AIR- RY"
"AIR- RY"
indicator light
that means the "AIR- RY"
program is chosen.
Cotton
Washing for cotton textiles