12
Hot water inlet hose
Cold water inlet hose
Steps for Installation
• Select a suitable location for the washer on a hard even surface away
from
direct sunlight or heat source e.g. radiators, baseboard heaters,
cooking
appliances etc. Any floor unevenness should be corrected with
the leveling
legs located on the bottom corners of the washer. The
washer must be placed
at room temperature. You must not place washer
where the temperature is at
below freezing.
For this machine having ventilation openings in the base, make
sure
the
openings must not be obstructed by a carpet.
Installing Your Washer
Read installation instructions carefully before installation.
1. Do not use water inlet hoses without a flat washer on each end. The
washer
in the coupling has to be placed firmly. Flat water inlet hose
washers are
preinstalled in each end of the water inlet hoses.
New hose-sets supplied with the appliance are to be used and that old
hose-sets should not be reused.
NOTE:
You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause damage to the valve.
2. Connect the hot and cold water inlet hoses to the hot and cold water
faucet.