11
Use the operation buttons
Off
On: indicate the program about to run,or indicate
the selected mode or indicate the water level
Flashing: indicate the running program
It displays “--” during detecting.
z
It displays total remained time during the
z
running program (min).
It displays remained reserved time during
z
reserve program hour
It displays abnormal symbol in abnormal
z
situation.(See to Page 14)
Program
Applicable situation
SOAK
Washing the relatively big thick or very
dirty laundries
STANDARD Common washing
If “STANDARD” program is set, the
machine will execute fuzzy detection. The
computer will set the water level and
washing time as per the cloth and quantity
of the laundries.The whole procedure is
under automatic control.
SOFT
Washing the woollen textiles
QUICK
Posthaste wash of the laundry under 2.0
kg with light soil.
T
he water level will automatically set 24L.
WASH
Just run the washing cycle without
drainage cycle. The detergent was left
inside the drum and can be recycled.
RINSE
Remove the left detergent from the clothes
and then rinse the clothes
SPIN
When the clothes are washed or the
clothes are quite wet, extra spin is needed.
TUB DRY
Drying the inner tub and the outer tub,
which can avoid growing mildew.
After the power is switched on,press it to start
the machine.
During working, push it to pause.
z
During pause, push this button to restart
z
and go on working
Push the On/Off button to switch on the
z
power.
When the power is on, push it again to
z
switch off the power.
the power.If the start/pause button is
not pushed, the washing machine will
z
automatically switch off the power
after 5 minutes.
The digitron displays the time remained
z
(in minute) before the washing is
¿
nished.
Push down the reserve button. The reserve
z
indicator light is on the digitron displays the
reserve time of
¿
nishing washing (in hour).
When the machine is started, the reserve
z
indicator light is on, indicating that the
reserve function is running.
The washing machine can detect the
z
laundries automatically during the
STANDARD program
After detection,
it will set the water level to suitable value
among 30L,40L and 50L automatically.
You can also set water level by yourself.
z
After the machine is started, it will not set
water level automatically. You shall push
the start/pause button to make new setting.
If there’s water inside the tub, the machine
z
cannot detect the laundries and will display
water level 40L .If wet laundries are put in,
it may display water level 50L. You must
set suitable water level by yourself.
If quick program is selected, it will display
z
water level 24L.
If tub dry program is selected, the water
z
level will not respond.
During operation of wash and rinse
z
program, you can push down the water
level button to add water. When you
release the button, or it reaches the
over
À
ow water level, the machine will stop
adding water.
The water level decided may be different
z
from actual value because of the different
moisture level of the laundries.
The rinsing water level is one water level
higher than the washing water level( except
the maximal and man-rated water level).
z
Push the On/Off button to switch on