Haier HW90-B14939S8, Руководство пользователя, Страница: 27 / 32

Following connections are possible:
10.6.1 Drain hose to sink
▶
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-7).
▶ -
ping.
10.6.2 Drain hose to waste water connection
▶
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶
Put the drain hose for 80-100mm in the wastew-
ater pipe.
▶
(Fig. 10-8).
CAUTION!
▶
The drain hose should not be submerged in water and should be securely xed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being lled (self-si-
phoning).
▶
Drain hose is not to be extended. If necessary contact after sales service.
10.6.3 Drain hose to sink connection
▶
The junction must lie above the siphon.
▶
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 10-9).
▶
Secure the drain hose with a clamp.
10.6 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! If possible keep always drain
WARNING!
▶
Use only the supplied hose set for the connection.
▶
Never reuse old hose sets!
▶
Only connect to cold water supply.
▶
Before connection, check whether the water is clean and clear.
10-7 10-8
10-9
10-Installation
EN
27