7
Drain Hose
Use the drai
●
n hose bracket to keep the end of the
drain hose re
●
tained and prevents the
of
water.
Don't
●
extend the length of the drain hose; if an extended hose is required, please consult a
serviceman or plumber.
The height of the drainage outlet must be 80cm -100 cm.
Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping o .
The drain hose should not be submerged in water and should be securely xed and leak-free.
If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the
washing machine will con nuously drain while being lled (self-siphoning).
Conne ng to Power Supply
Before connec ng t
●
o the power supply, check:
The socket is adequate for the maximum power of the washing
machine (Fo
●
r safety, fuses in the power circuit should be rated
for no less than 16A).
The voltage should meet the requirement
The power outlet should be capable of accep ng the washing
machine plug.
Connect the machine to an earthed socket outlet.
Inlet Hose
Connect the nut on the inlet hose to the
connector on the water valve
.
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
water inlet joint on the faucet, Make sure the screws is in
water inlet joint
lock pole
Slider
Water pipe
1.
2.
screw
3.
4.
5.
picture 1
a. Hold down the lower end of the lock pole,Then hold the
inlet pipe, press on the slider, and remove the water
inlet joint (picture 2).
c. Press the slider and insert the water pipe into the water inlet joint,
hang the water inlet joint with a lock pole and release the slider
