Haier HW100-B16939, Руководство пользователя, Страница: 81 / 96

1. At programme cycle end END is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the programme.
Press the “Anti-crease” button and ”Temp.” button and “Extra Rinse” button at the
same time for about 3 seconds. “
BEEP OFF
” will be displayed and the buzzer will be
deactivated.
. 3
To interrupt a running programme press gently “Start/Pause“. The LED above the button
is fl ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press ”Start/Pause” button to interrupt the running programme.
2.
3. After closing the programme to restart the appliance,select a new programme and
6.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos
-
sible to open the door at the end of the programme or after the programme was can
-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos
-
sible to open the door; Loc
l-
is displayed.
Note: Standby-mode / energy -saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
6.10 Start wash programme
Press “Start/Pause” button (Fig. 6-8) to start. The LED stops fl ashing
and lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
6-8
EN
6-Daily use
17
Turn the knob to select the programme "Spin" and Press "Speed" (selcet speed "
0
")
X I M
start it.
▶
▶
For activating the buzzer touch these three buttons at the same time again. “
bEEP ON
”
will be displayed.
to drain the water.
minutes before starting the programme or at the end of programme. The display
switches off. This save energy.