3
3
3
3
•
Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles.
•
Slide child safety button then push the hot water faucet until water comes out, then stop.
•
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to
do that, wait for the hot water to reach temperature in approximately 10 minutes, and then wait
for the cold to reach temperature (another 40 minutes, approximately).
•
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at
a time until no more water remains.
(Note: To facilitate this operation, use a large container).
•
Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains
completely.
•
Proceed to close the drain cap.
•
Remove the cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.
•
Place the 5-gallon bottle of water on the water intake, allow water to stand for approximately one
minute.
•
Push water faucet buttons to insure water flows from both faucets.
•
Plug dispenser back into the electrical outlet.
•
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined, except turn hot water function “OFF” to
avoid leaving residues in hot water tank.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we
recommend that you turn off the hot water function.
OPERATING
OPERATING
OPERATING
OPERATING YOUR
YOUR
YOUR
YOUR WATER
WATER
WATER
WATER DISPENSER
DISPENSER
DISPENSER
DISPENSER
Steps
Steps
Steps
Steps To
To
To
To Replace
Replace
Replace
Replace Water
Water
Water
Water Bottles
Bottles
Bottles
Bottles
�
�
�
�
Remove cap.
�
�
�
�
Use a clean cloth to wipe off neck of bottle.
�
�
�
�
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
�
�
�
�
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
�
�
�
�
Wipe off any water which may have splashed on dispenser top.
�
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full
cups of water to insure the water flows properly and the water reservoir is at the proper level.
TAKING
TAKING
TAKING
TAKING DISPENSER
DISPENSER
DISPENSER
DISPENSER OUT
OUT
OUT
OUT OR
OR
OR
OR SERVICE
SERVICE
SERVICE
SERVICE
�
If the water dispenser will not be used for a long period of time, unplug the power supply
cord.
�
Turn off the hot water.
�
Drain the water through the faucets.
�
Drain the water from tanks by drainage hole from the back of the dispenser.
CAUTION
CAUTION
CAUTION
CAUTION
�
Do not use the bottle with any crack, leakage or holes.
�
The back of the product should be put in shady places and kept away from wall and high-
temperature elements. Please also put the product away from TV, video, or other
