Haier HDW15F3S1, Руководство пользователя

Страница: 32 / 40

Many occuring problems could be solved by yourself without specific
expertise. In case of a problem please check all shown possibilities and follow
below instructions before you contact an after sales service
CAUTION!
Before maintenance, deactivate the appliance and disconnect the
power plug from the power socket.
Electrical equipment should be serviced only by qualied electrical
experts, because improper repairs can cause considerable
consequential damages.
The appliance does not start, or it stops during operation
Problem Possible cause Possible solution
The programme
does not start.
Appliance door is open. Close the appliance door.
Refer to displayed time.
Connect the power plug.
Fuse in the house circuit is
damaged.
Replace the fuse.
Rinse Aid Indicator
is light.
Rinse aid dispenser is empty. Refill Rinse aid until full.
Delay start is set.
Power plug is not connected
in the power socket.
Acoustic alarm,
display shows
ALARMCODE
The
not fill with water. appliance does
Water tap is closed.
• Open the water tap.
Note: Whenever Error ‘ ’ is
solved switch off the appliance
and restart the programm.
Water inlet hose has a kink or
a bend.
Make sure that the position of
the hose is correct.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
The hose must be replaced.
Filter in the water inlet hose
is clogged.
Water inlet is clogged. Check water flow from tap.
Water pressure is too low.
Contact your local water
authority.
Clean the filter at the inlet hose
connections at tap and the rear
of the appliance.
Error codes on the display
31
Troubleshooting
NZ AU