31
Installation
Drain hose to waste water
connection
▶
The
internal
diameter
of
the
stand
pipe
with
vent-hole
must
be
minimum
40 mm
.
▶
Put
the
drain
hose
for
approx. 80 mm
in the wastewater pipe.
▶
Attach the U-support and secure it
Drain hose to sink connection
▶
▶
CAUTION!
Ensure always that all connections (power supply, drain and fresh
Take care these parts are never to be crushed, kinked, or twisted
If the supply cord is damaged, it must be replaced by the service
agent (see warranty card) in order to avoid a hazard.
Drain Water Connection
Fix the water drain hose properly to
the piping. The hose has to reach at one
point a height between 400 and 850 mm
above the appliance bottom line!
An extension hose for the water drain
hose must not exceed a total length of
4 m and must have the same diameter as
the water drain hose.
Following connections are possible:
Drain hose to sink
▶
Hang the drain hose with the
U-support over the edge of a sink
with adequate size.
▶
against slipping.
water hose are firm, dry and leak free!
)
When connecting the drain hose to a
sink trap with a drain hose spigot, make
sure that the drain hose is supported
to the height of the bench.
Ensure the drain spigot has a minimum
hole diameter of 15 mm and it has been
drilled out.
