Haier HD90-A636, Руководство пользователя

Страница: 26 / 34

Troubleshooting
GB
26
* The drying cycle is automatically cancelled after 7 hours.
Troublesshooting without display-codes
Problem Possible cause Possible solution
Tumble dryer
fails to operate.
• Programme is not yet started?
• Delay function is activated?
• Door is not properly closed?
• Machine has not been switched
on?
• „Start/Pause“ button was
pressed?
• Appliance is connected to the
power supply?
• The water tank is full or not
properly installed?
• Child lock is activated?
• Check programme and start it.
• Cancel the delay start.
• Close the door properly.
• Switch the machine on.
• Press „Start/Pause“ button.
• Check power supply.
• Empty the water and install
it properly; press the „Start/
Pause“-button.
• Deactivate child lock.
Appliance fails
to operate and
the display
shows End .
• The laundry has reached the
dry level defined by the pro -
gramme?
• There is no laundry in the drum?
• Check the programme set -
ting and post-dry if necessary.
• Check the drum.
The drying
results are not
satisfactory.
• The programme setting is not
correct?
• The correct dry level was chosen?
• The filter is dirty?
• The condenser filter is dirty?
• The heat exchanger is clogged?
• T he ventilation slots are clogged?
• The tumble dryer is overloaded?
• There is a coating on the inner
surface of the drum?
• The laundry was too wet?
• Dirt is on the moisture sensor in
the drum?
• Warm laundry feels more moist
than it really is.
• Check the programme set -
ting.
• Check the dry level.
• Clean the lint filter.
• Clean the condenser filter
• Clean the heat exchanger.
• Clean the ventilation slots.
• Reduce the amount of laundry.
• Clean the inner surface of the
drum with a cloth soaked in
vinegar.
• Spin the laundry properly be -
fore drying.
• Clean the front surface of the
drum with a cloth soaked in
vinegar.
• Spread out laundry that the
heat can escape.
Drying time is
too long.*
• The condenser filter is dirty?
• The tumble dryer is overloaded?
• The laundry was too wet?
• Ambient temperature is too
low?
• Clean the condenser filter.
• Reduce the amount of laundry.
• Spin the laundry properly be -
fore drying.
• Pay attention to the installa-
tion instructions. and increase
the ambient temperature, if
possible.