4
² »
Ò ª
° ²
× °
Ó Ú
Î Þ
· ¨
Å Å
Ë ®
µ Ä
µ Ø
· ½
Using method
After the power is turned on, the upper indicator lamp illuminates and the upper heating
element starts heating. When the temperature of the hot water in the water heater
reaches 60
, the upper indicator lamp goes out, the lower indicator lamp illuminates
and the lower heating element starts heating. The water heater continues to work.
When the lower indication lamp goes out, the water heater stops working and the whole
water heater reaches the rated temperature 60
.
The rated temperature of the water heater is 60 . The indicator lamps will illuminate in
heating state. When it reaches the rated temperature, the power will be turned off and
the indicator lamps will go out.
Large amount of water will come out from the drain hose of the relief valve if the
pressure of the tap water is higher than 0.7MPa. This is caused by overly high water
pressure. Please call the after-sales service center. Water or vapor will come from the
drain hose of the relief valve if the temperature of water inside the inner tank exceeds
. It is reducing temperature by relieving pressure as the temperature is too high.
Please call the after-sales service center in this case. Please keep away from the drain
hose during use to avoid scalding.
99
9
Using method
In initial use after installation, it must be fully filled with water before turning on the
power.
In first use, as the inner tank is empty, you must turn on the tap and one of the water
outlets. Wait until water comes out continuously
(it indicates the tank
is full) and then turn off the water outlet.
Check all the joints for leakage. After that, plug in the power cord.
from water outlets
Setting environment
Setting environment
Description of the symbols
This symbol indicates actions you shall never do! Neglecting these instructions may
cause personal injury or even death.
This symbol indicates instructions you must observe! Neglecting these instructions
may cause personal injury or damage to your house or property.
D o n o t i n s t a l l i t o u t d o o r .
Do not install it in a place without
drainage.
Do not place it in a cold environment
where it tends to freeze. The tank
and the tubes may break if water in it
freezes. This may cause leakage and
scalding.
If drain hose is connected, please
connect it to the inlet of the sewer to
avoid polluting by splashing.
