Haier ES100V-A3, Инструкция по эксплуатации

Страница: 20 / 36

8
Installation
Install the safety valve which has a rated pressure of 0.80MPa (its connection is G1/2) into
the water intake pipe with the arrow on the safety valve pointing at the water heater. When
the water heater is heated by electricity, a small amount of water will flow from the safety
valve’s pressure relief hole due to the expansion of water in the heater. This is normal. The
pressure relief hole should be connected to the atmosphere and free from blockage at all
times.
Installation method for safety valve’s drainage pipe: Attach an end
of the water drainage pipe onto the pressure relief hole on the
safety valve. You may cut the water drainage pipe to make it
shorter, or extend it depending on the situation. Connect to the
other end of the water drainage pipe to the lower water outlet.
This will prevent the water from the pressure relief hole from
splashing. The water drainage pipe connected to the safety valve
is to be installed in a continuously downward direction and in a
frost-free environment.
Note: If your water heater is not installed in a bathroom with sewer, our recommendation
would be that you add safety valve water drainage pipe.
Note: The water may drip from the discharge pipe of the pressure relief device (safety
valve) and that this pipe must be left open to the atmosphere.
Safety valve
Mini handle
Pressure relief hole
(connected to water
drainage pipe)
Installing of safety valve
ES30V-A3
ES50V-A3
ES80V-A3
ES100V-A3
Electric water
heater
(Unit)
Safety valve
(Pc.)
Expandable Hook
(Pc.)
Instruction
manual
(Unit)
Product Model
No.
Name of parts
Quantity
Packing list