Haier DW9-TFE3-F, Руководство по обслуживанию

Страница: 29 / 43

28
Service Manual
Model No: DW9-TFE3 Series
Issue
Rev.
13-5.Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 24 hours.
● Close the door after loading the appliance.
● Switch dishwasher
ON
.
● Immediately press the Delayed Start button “
F
”, the delayed start indicator “
E
” blinks, the
remaining time indicator “
G
” changes to “ 1h”.
● Press the Delayed Start button for 2 seconds until the numerical display show the required
delay.
● To cancel the time delay setting, pressing the Delayed Start button until the delayed start
indicator “
E
” goes out.
● Rotate programme knob
“ J ”
to select the desired programme.
After 3 seconds the delayed start indicator “
E
” blinks, the time-remaining indicator “
G
” will blink
and decrease , the programme will start until the delayed start indicator “
G
” goes out.
13-6.Cancelling or modifying a cycle
● A cycle that is underway can be modified if it has only been running for a short time. Otherwise,
the detergent may have already been used, and the appliance may have already drained the
wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading
the detergent ”).
● To modify a cycle that is already underway, follow the instructions contained in the paragraph
entitled
"Reset drain function", and select the programme you wish (see the paragraph entitled,
"Switching the dishwasher ON").
13-7.3in1 function
When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may
be helpful to select the lowest possible setting for water hardness.
If you decide to switch to the use of a standard detergent system we advise that you:
1: Refill both the salt and rinse aid compartments.
2: Switch the water hardness setting to the highest possible position and run for three normal
cycles without a load.
3: Readjust the water hardness setting again according to the conditions for your region (For
more information please refer to your instruction manual).