23
Service Manual
Model No: DW12-PFE2-E/DW12-PFE2-U/DW12-PFE2ME-U
Issue
Rev.
11. Turning on the Appliance
Switching the dishwasher ON
·Turn on the tap
·Set ON-OFF button"A" to ON.All the programme
indicators "J1,J2,J3,J4,J5,J6"light
·Press programme button "I1",programme indicator "J1"
lights and the time-remaining indicator "F" displays the
time of the programme
·If the door is closed,after 3 seconds,the programme
indicator "J1" becomes to blink and the dishwasher
beeps one time,then the programme starts automatically.
End of programme
Six beeps will indicate that the wash cycle has finished and all the programme indicators light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
--Set main switch “A” to OFF.
--Open the door .
--Turn the water tap off.
--Remove dishes, etc. when they have cooled down.
W
hen the appliance is already underway press the button "A" for 3 seconds, all of the
settings will be canclled.
Interrupping the programme
--Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not
open the door fully until spray arm has stopped rotating.
--When you open the door, the dishwasher will beep ten times every thirty seconds.
--If the appliance has already heated up or the hot water was switched ON and then the appliance
door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance
door may open due to expansion
.
Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 12 hours.
--Switch dishwasher ON.
--Immediately press the Delayed Start button"D",the delayed start indicator "E" lights,the delayed
start time indicator "F" changes to "1h"
--Press the Delayed Start button “ D ” as many times as necessary until the numerical display
shows the required delay.
--To cancel the time delay setting, pressing the Delayed Start button until the delayed start
I1
J1 J2 J3
J4
J5 J6
A
F