17
You can use "Reset drain function"to stop the washing cycle under running by pressing and holding
the "C1" and "C3" for 3 senconds, and the appliance will stop after a few minutes drain phase.
Reset drain function
Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the
detergent ”).
To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled
"Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching
the dishwasher ON")
Interrupting the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set main switch “A” to OFF.
Open the door .
Turn the water tap off. (Does not apply when Aquastop unit has been fitted)
Remove dishes, etc. when they have cooled down.
End of programme
Six beeps will indicate that the wash cycle has finished and all the programme indicators light.
C1
C3
When the appliance is already underway press the button "A" for 3
seconds, all of the settings will be cancelled.
en
Содержание DW12-PFE1 S
Страница 1: ...Code 0120501388 Dishwasher DW12 PFE1 Instructions for Use ...
Страница 2: ......