SERVICE MANUAL
Model: AFL631 & CFE633
14
Issue 200905
Rev. Ref0905S003V0
(5) Pull the axis from the upper hinge. Then, insert it from the other end of the upper hinge. Insert the
upper hinge by placing the axis into the door axis hole after turning 180 degrees.
(6) Remove the stop block on the bottom of the door and then reatacht on the other side of the door
after turning 180 degrees.
(7) Turn the middle hinge by 180 degrees and then fit it on the other side of the cabinet.
(8) Hang the door on the middle hinge and secure the hinge’s screws. Connect the two connectors
together. Tuck the cables for the door into the conduit on the other side of the door and the cables
for the cabinet into the upper hinge conduit.
(9) Tuck the connected connectors into the conduit on the upper decoration strip and joint the upper
decoration strip on the door.
(10) Turn the decoration piece by 180 degrees and insert it between the door and the upper decoration
strip at the other side of the cabinet.
Note: for the models with cabinet display, the above operation concerning cables is not needed.
3-2-3: Dismantle and install the middle and lower hinges
PART-3
Before change
After change
(1) Detach the 3 screws affixed to the middle hinge and remove the hinge. Unscrew the hinge axis
and then screw it from the reversed direction.
(2) Remove the upper and lower doors separately. Dismantle the stop blocks on the bottom of the
doors. Turn them by 180 degrees and refit them on the other side.
(3) Tilt the refrigerator to the required angle. Detach the screws fixing the lower hinge and remove the
Middle hinge
Screws
Middle hinge axis
Hole plug
Screws affixed to the lower hinge
lower hinge