Haier AFD631 Series, Руководство по обслуживанию

Страница: 14 / 35

DISASSEMBLY
⑵
Detach the 2 screws fixing the front decoration strip of the table-board.
⑶
Lift the front decoration strip of the table-board outward and upward. At this time, there are
wires connecting it. Please do not disconnect the wires. Gently put the front decoration strip
on the top of the refrigerator.
⑷
Detach the screws affixed to the upper hinge and remove the hinge.
⑸
Turn over the upper hinge and fix it on the other side. Then, install the front decoration strip of
the table-board in the reversed direction.
⑹
Secure the 2 screws on the top.
⑺
Install the 2 decoration covers on the front decoration strip of the table-board with their
positions exchanged.
⑻
Note: for the models with cabinet display, the front decoration strip of the table-board is
different from the one shown in the figure. The dismantling and installation methods are the
same.
Part 2:
Directions on how to dismantle and install the upper decoration strip and cables
⑴ Remove the decoration covers from the door and retain.
⑵ Remove the upper decoration strip from the door. Insert a “-”screwdriver into the decoration
strip at the position shown by the arrow and lightly pull the screwdriver handle in the arrow
direction while pulling the decoration strip upward with another hand. In this way the
decoration strip will detach away from the door. The operation methods on the right side and
the left side are the same.
⑶ Disconnect the connectors and pull out the cables in the door conduit and the cables in the
upper hinge conduit respectively.
⑷ Loosen the screws affixed to the upper hinge to remove the hinge. At the same time, the
refrigerating compartment door can be lifted up and separated from the middle hinge.
⑸ Pull the axis from the upper hinge. Then, insert it from the other end of the upper hinge. Insert
the upper hinge by placing the axis into the door axis hole after turning 180 degrees.
⑹ Remove the stop block on the bottom of the door and then reatacht on the other side of the
door after turning 180 degrees.
⑺ Turn the middle hinge by 180 degrees and then fit it on the other side of the cabinet.
⑻ Hang the door on the middle hinge and secure the hinge’s screws. Connect the two
connectors together. Tuck the cables for the door into the conduit on the other side of the door
and the cables for the cabinet into the upper hinge conduit.
⑼ Tuck the connected connectors into the conduit on the upper decoration strip and joint the
upper decoration strip on the door.
⑽
Turn the decoration piece by 180 degrees and insert it between the door and the upper
decoration strip at the other side of the cabinet.
⑾
Note: for the models with cabinet display, the above operation concerning cables is not
needed.
Part 3:
Directions on how to dismantle and install the middle and lower hinges
⑴ Detach the 3 screws affixed to the middle hinge and remove the hinge. Unscrew the hinge
axis and then screw it from the reversed direction.
⑵ Remove the upper and lower doors separately. Dismantle the stop blocks on the bottom of
the doors. Turn them by 180 degrees and refit them on the other side.
１３