1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming the inner cover
shaft to the installation hole of the corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the corresponding outer tub
cover shaft groove, then push the another inner cover shaft into the corresponding outer
tub cover shaft groove. Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner cover, and the operation
shall be smooth. Do not dismount the inner cover component after washing.
Outer tub cover
Outer tub cover shaft groove
Inner cover shaft
Inner cover component
Figure 1
Right hand
Left hand
Figure 2
The washing machine shall be more than 20mm away from the wall.The largest allowed
slope of the supporting base of the machine is 2
. The slanting or rough ground will
result in unstable running or stoppage of the machine. Please adjust it with following
methods:
Confirm it's horizontal:
Adjust the adjustable foot:
Hang the lead line to confirm if it is horizontal.
Adjust the installation position
Loosen
Fasten
High Low
adjustable nut
adjustable foot
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
1.To twist the adjustable foot, please first
lift up the side of the foot slightly, loosen
the adjustable nut, and twist the foot.
2.Fasten the nut after adjustment.
Install the bottom plate
After you open the package, please lean the washing
machine gently down on softitems ( like the towel cloth,
blanket, etc. ). Install the bottom plate to the bottom of
the machine with the eight screws by a cross screwdriver,
then lift the machine up gently. See to the figure:
soft items
Bottom plate
Screw
Back
Front
Page 9
Page 10
WATER LEVEL
After switching on the power, the washing machine will set to common program including"wash, rinse,
spin "automatically.To select other procedures, push the " WASH"," RINSE"or "SPIN"
button to select the
time of wash and spin, and the times of rinse. After switching on the power,if you push one of the
button among "RINSE"and"SPIN the digitron of the former procedures will turn off automatically. The
former procedures will not run. For instance: after switchingon the power. If you push the "SPIN" button
first, it will execute spin singly after starting.
Even there's no water in the tub, a certain period is
required before spin starting.
Separate the laundries that are not colorfast from
other laundries in washing.
Do not use the HEAVY program for the woollen textiles.
The pulsator will not rotate unless the water is
filled to water level .
Attention
After the machine starts operation, you can set the program and procedure during washing,
set spinning time during rinsing but can not make setting in other cases.
Press " WATER LEVEL "button,
select suitable water level
After switching on the power, select a suitable water level to detect the cloth. To select other water level.Refer
to "water level, water quantity and desoge of powder"in Page 9 and "WATER LEVEL/DISINFECT"button in Page
10 for the selection.
4
13
Install the inner cover
