4
RUNNING YOUR CAR
1
TURN ON THE RADIO CONTROLLER
2
TURN ON THE RECEIVER ON YOUR CAR
Power Switch
CAUTION
Before using your car, make sure the radio controller is of enough battery power.
Low battery power will lead to the loss of control of your car.
Always turn on the remote controller firstly, and then the receiver.
TO BIND THE RECEIVER TO THE RADIO CONTROLLER
1)Turn on the 3-in-1 unit power switch ,
which is located on the side of the car.
(Note: Receiver and ESC are combined inside
the 3-in-1 unit.)
2) Hold the Bind(Pair) key, switching on the
radio power.
This operation should be performed within
5 seconds after your receiver is turned on.
3) Green indicator goes flashing, meaning
that the binding process is being performed
in system.
4) Red and green indicators being steady on
means that your receiver is bound to your
radio controller. Binding process is
completed.
Before running , make sure that the radio controller is bound with the receiver, which have normally
been done at factory. If it is not the case, you are require to perform the binding procedure following
the instructions below.
