1
1
3
3
OWNER'S MANUAL
Following Installer Setup, check the option boxes (
) in the Owner's Manual according to the configuration of
the thermostat.
QUICK-REFERENCE SETUP GUIDE
This table displays each Installer Setup item with its default setting. The column labeled "CURRENT" can be
used to write down the current settings if any changes are made to the default settings.
Item Number
Description
Default
Current
00
Address
1
01
Communication mode
1
02
System options
0
03
Display options
1
04
Calibration offset
30
05
Cool setpoint limit
51
06
Heat setpoint limit
91
07
Not used
-
08
Not used
-
09
Cooling anticipator
4
10
Heating anticipator
4
11
Cooling minimum on/off time
8
12
Heating minimum on/off time
8
13
Not used
-
14
Clock adjust
30
15
Filter reminder
10
16
System runtime (This week)
-
17
System runtime (Last week)
-
REMOTE SYSTEM WIRING DIAGRAMS
This thermostat has been preprogrammed with energy saving settings recommended under the EPA Energy Star
program. When used with remote systems, HAI recommends that the thermostat be configured as "non-
programmable" (See Setup Item 03 - "Display Options").
HAI AUTOMATION SYSTEMS
The thermostat can be connected to an HAI automation system. The controller can send commands to the
thermostat to change mode, cool setting, heat setting, status of fan and hold, and other items.
Run a 3 (or 4) conductor wire from the HAI system to the thermostat location. All thermostats on an Omni,
Omni II, OmniPro, or OmniPro II controller are connected to Zone 16 and Output 8.