HAI OMNI LT, Руководство пользователя

Страница: 24 / 70

20
Scene Off Command
Once the Scenes have been sent, press the 0 (OFF) key to command the four units in that Scene to turn off.
Notes:
1.
When sending Scene Commands, the controller must be configured to allow Extended Code transmissions.
2.
The Scene Commands always apply to a group of four consecutive units, which are units 1-4, 5-8, 9-12, and 13-16. You
must address the units accordingly so that the desired units fall into the appropriate lighting groups.
3.
The actual Extended Code Scene commands use a "group reference" that matches that sent by a Leviton Wall-Mounted
Scene Controller set to the same address as the first unit in the lighting group. This allows wall-mounted controllers to be
easily used for manual Scene selection.
Buttons
A powerful feature of the OmniLT is the ability to program
Buttons . A Button (also known as macro) is a number on the keypad
that is programmed to run a series of commands when it is pressed. Buttons are used to program functions that are specific to
your home and lifestyle.
Using a button, you can activate several commands at once. You can personalize 16 buttons with descriptive names. Following
are some examples of programmed Buttons:
Leave for Work (Button 1):
- turn off all lights
- set thermostat to energy saving settings
- arm the security system in the Away mode
Go to Bed
(Button 2):
- turn off all lights
- dim outdoor lights 20% to extend bulb life and reduce consumption
- arm security in Night mode
Dinner for Two
(Button 3):
- dim the dining and living room lights
- turn on the porch light
- turn off all the bedroom lights
- dim the den light
- turn on the stereo
To activate a preprogrammed button, from the top-level display or from the main menu, press the 3 (BTTN) key on the console
keypad. Select the button (macro) to be activated by using the arrow keys to scroll through a list of buttons, followed by ' # '.
For extra convenience, event buttons are automatically activated when you change security modes, or when security zones open
and close. This powerful feature allows you to set your system up so that control functions are performed when you arm your
security system (such as turning off all lights and setting back the HVAC system). Door contacts and motion detectors can be
used to turn on lighting automatically, then turn it off a few minutes after the person has left, and then only if it's dark.
Temperature Control
Your OmniLT can control temperatures of your heating and cooling system, monitor the outside temperature, and detect high and
low temperatures in special situations. Other appliances can be controlled by temperature as well - such as a bathroom heater or a
ceiling fan.
The temperature menu is used to control HAI Communicating Thermostats, Programmable Energy Saver Modules, and
Temperature Sensors. The status of each of these may also be displayed on the console.