HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]
•
Cover the installation frame.
•
Slowly raise the lift with the remote control. At the end, adjust the threaded
rods so that the mounting frame is let-in flush with the rest of the ceiling.
•
Pay attention to the maximum load of the lift
•
Check the positioning by a test run of the lift and make sure that it fits into the
suspended ceiling without resistance. If necessary, adjust until the panel fits
exactly into the inserts.
Trial run after installation
A trial run must be performed to:
•
check the position of the cover to the suspended ceiling to avoid blockage.
•
check the length of the cables in the lower end position.
•
check that there are no loose parts in or under the lift.
•
check the voltage of the 220 V socket / power supply for the lift.
Now you can finally connect the power plug to a rated socket near the lift in the ceiling.
If necessary, install strain reliefs for the cables and the plug connections. Fix all supply
cables so that no cables can come loose and get caught in the beamer lift.