Flush-
The crown is fully screwed-down. The watch is completely sealed
and the movement protected. This is position zero.
(1st Position)
For Setting the Date position. This is position one. Gently
unscrew the crown counter clockwise and gently pull out to one click.
(2nd Position)
For Setting the time position. Gently pull out the crown to
the second position. When completed, lightly push the crown back into
position zero and gently screw the crown in clockwise direction, then
tighten it again until you feel some resistance.
Do not force! You must
always ensure the crown is fully tightened before any use in water.
1
1. Setting the time:
1.1. Pull out the crown to the second click position.*
1.2. Turn the crown to set the hour and minute hand.
1.3. Check that AM / PM is set correctly by looking at the 24-hour sub-
dial in the 3 o’clock position.
1.4. Push in the crown to the normal position.
•
If the crown is pulled to the second position while the chronograph is
started, the chronograph hands will continue to move. This is not a
malfunction.
2. Setting the date (for models with date windows):
2.1. Pull out the crown to the first click position.
2.2. Turn the crown clockwise to set the date.
* Do not change the date when the hands are set between 9 PM and
3 AM, because the day may not change properly. If it is necessary to
set the date during that time, first change the hands to any time
outside of that range; then set the date and then reset the correct
time. (Use the 24 hours sub-dial located at 3 o’clock to help you
when setting the date)
2.3. Push in the crown to the normal position.
.
U-2 OPERATING INSTRUCTIONS
