BODYGUARD-T
Installation Instructions
I-EA00206
Rev 01, Rev Date: 05/08/2018
Page
1
of
12
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
1. DESCRIPTION
The Hager Bodyguard-T (10BODYGUARDT) are self-monitored ready, overhead-mounted, diffused active infrared sensing devices that provide detection
for triggering automatic, swing-door safety functions. These sensors are designed for use with all of Hager’s LO21 modules. When used with Hager’s
lockout devices, these sensors are programmed to allow two different fields of detection – one for detection when the door is in the fully-closed position
and the other for detection when the door is fully open. While the door is in the fully-open position, the Bodyguard-T extends its coverage back through
the threshold area of the doorway, to provide coverage that will overlap with Hager’s motion sensors.
As with all of Hager’s programmable sensing devices, full adjustability is achieved with the use of Hager’s hand-held remote control unit. This allows
alteration of all available functions as well as inquiry of existing settings. Should the need arise, the
Bodyguard-T
may also be tuned by means of two sensor-mounted buttons contained on the PC board within the unit. With these two buttons, the
Bodyguard-T’s field of detection can be altered without the use of the hand-held remote.
If a complete door-mounted sensor (SuperScan) system is not used in addition to the Bodyguard-T, Hager recommends the use of a lockout safety
beam to allow safety signaling if the zone is entered during a door closing cycle.
NOTE:
If utilizing monitoring, lockout modules may
not
be used. If lockout modules must be used, monitoring is
not allowed
.
NOTE: For BODYGUARD-TC functionality, set Immunity to 3-HIGH.
2. SPECIFICATIONS
DESCRIPTION
SPECIFICATION
Installation Height - Variable
9’ 0” max. (recommended 6’ 6” – 8’ 0”)
Mounting Angles
Bodyguard-T only
Bodyguard-T with Bodymount
5°, 10° (factory default setting: 5°)
0°, 5°, 10°
Power Supply
12 – 24 VAC / VDC ±10%
Monitoring Request Input
12 – 30 VDC required (polarity-sensitive)
Min. pulse width 10 ms (active low)
Frequency
50 – 60 Hz
Output
Max. Voltage at contacts: 60 VDC / 125 VAC
Max. Current at contacts: 1 A
Max. switching power: 30 W (DC), 60 VA (AC)
Relay Hold Time
0.5 – 9 seconds
Operating Temperature
-22 – 140 °F
Immunity
Immune to electrical and radio frequency interference
Cable
4’ nine-conductor cable
Weight
1 lb 11 oz (765 g)
Dimensions
11.8” (305 mm) x 1.9” (51 mm) x 1.9” (46 mm) (L x H x W)
Material
Aluminum & ABS plastic
Housing Color
Black, anodized aluminum
DEVICES COVERED IN THIS DOCUMENT:
2-659-0332
2-659-0034
2-659-0333
