4
NEW BI-SIZE
70/80 x 90 RH-LH
80/85 x 80/85
90 x 90
Plumbing and electrical layout
KEY
A
- 1/2” cold water wall attachment.
B
- 1/2” hot water wall attachment.
C-D-D1 hose exit
C
- Power cable exit ( length min. 2 [m] )
D
- Equipotential cable exit ( length min. 2 [m] )
D1
- Alarm cable exit ( length min. 2 [m] )
O -
Floor drain ø40/50
O1 -
Wall drain ø40/50
Connections C and D1 only apply for models with Turkish bath.
Connections are specular for all models.
35
35
5
O1
O
A
B
C-D-D1
200
55
10
4
20
10
The shower booth must be installed by qu
r
personnel, for both the electrical and plumbing connections.
Before proceeding with installation, the installer must check that the electrical system is protected by a
ntial switch (0.03) and
that the earth system complies with the standards currently in force in the country of use.
The shower booth must be permanently connected to the electrical system (with a H05 - 3x2.5mm tri-polar switch with a 2.5 mm
2
2
section) by means of a bi-polar switch (minimum aperture of the three contacts 3mm) suitable for the power (kW) of the product to be
connected, located outside zones 0,1,2,3, and far from possible water splashes.
The product must also be connected to the equipotential system of the building by means of the appropriate terminal located on the
frame.
It must also be possible for the shower booth to be removed at any time, without having to carry out any operations on the masonry.
WARNING:
if the given instructions are not observed, or only partially observed, the safety of the shower booth might be at risk: there-
fore the manufacturer’s guarantee will no longer be valid and the manufacturer will not be liable for any direct or indirect damage to
the product.
The annulment of the guarantee, as indicated above, will result in the replacement of the parts recognized as being faulty, without
covering labour costs necessary for the removal of the product.
GRUPPO GEROMIN
srl reserves the right to make alterations to the product at any time without prior notice
BAR
Operating pressure:
- MIN 150 kPa (1,5 bar)
- MAX 300 kPa (3,0 bar)
Hot water temperature:
- MAX 60°C (140°F)
If the water pressure is higher than indicated, install pressure reducers.
Provide shut-off cocks out of the dimensions of the product for hot and cold water closing.
