SPECIFICATIONS
POWER RATING:
Less than 0.006% total harmonic distortion at any
power level up to 60 watts continuous average power per
channel into 8 ohms at any frequency between 20 Hz and
20 kHz with both channels driven.
IM DISTORTION (IHF):
Less than 0.005% from 1 to 60 watts, each channel,
into 8 ohms.
TYPICAL THD AT 60 WATTS INTO 8 OHMS:
20 Hz: 0.002%
1 kHz: 0.002%
20 kHz: 0.006%
FREQUENCY RESPONSE INTO 8 OHMS:
-3dB, 4Hz to 2OOkHz at 1 watt.
+OdB, -0.5dB, 1OHz to 4OkHz at 60 watts.
TYPICAL CHANNEL SEPARATION:
2OHz: > 75dB
1kHz: > 85 dB
20kHz: > 65dB
SIGNAL TO NOISE RATIO, UNWEIGHTED:
Exceeds 1OOdB referred to 60 watts into 8 ohms.
INPUT IMPEDANCE: 22,000 ohms
INPUT SENSITIVITY:
1.1 volts rms for 60 watts into 8 ohms.
DAMPING FACTOR:
100 to 1kHz into 8 ohms, 50 to 1OkHz into 8 ohms.
POWER CONSUMPTION:
60 watts both channels into 8 ohms: 300 VA
Quiescent: 60 VA
SIZE: 3-1/4” high plus 1/2” feet, 17” wide, 9” deep.
(83 mm high plus 152 mm, 432 mm wide,
229 mm deep.)
NET WEIGHT: 18 lbs. (8.2 kg)
SHIPPING WEIGHT: 20 lbs. (9.1 kg)
Stereo/Mono Channel Operation:
The SE120 delivers 60 watts continuous average power per
channel into 8 ohms. It can be bridged for single channel
operation producing up to 120 watts of power into 16 ohms.
Input Mode Selector:
This switch will allow the user to specify the input signal to
the amplifier.
A. Stereo Mode:
This allows the right and left channels to reach their
designated amplifier channels. This mode will deliver
more than 60 watts into an 8 ohm load.
B. Mono Mode:
The SE1 20 can be operated in a bridged mode which drives
both channels with the same signal and combines to deliver
more than 150 watts into 8 ohms. This disables the right
channel input and routes the signal through the left channel.
Construction:
The simplified construction of the SE120 improves relia-
bility and results in consistent performance. The heavy
duty case construction on the SE120 will provide years of
durability and trouble free protection.
Gold Plated RCA Input Connectors:
This provides the most accurate signal transmission and
lowest possible loss. Gold-plated terminals are immune to
signal deterioration with time that can be caused by corro-
sion in the connectors.
Speaker Output and Power Connectors:
For minimum loss power transfer, high definition and
oxidization resistance.
Protection System:
The SE120 is equipped with a unique protection system
that constantly monitors the temperature of the output
devices and takes corrective action to prevent damage to
the amplifier as a result of excessive overheating.
ALL SPECIFICATIONS SUBJECT TO CHANGE
WITHOUT NOTICE.
Copyright
1990.
All rights reserved
-l-
