Assembly of the top roller fitting:
Release and remove the safety lock screws (B) from the ladder frame. Insert the top roller fittings (A) into the groove. Replace
the safety lock screws and tighten with a self-locking nut M5. Push in plastic caps (C). (See drawing below)
Assembly of bottom castors:
Place castor housing (D) to the exterior side of the frames and
securely
tighten with 2 pieces of hexagonal head bolts (E) and
steel springs (F) from the interior of the frames. (See drawing below)
Hooking in the sliding ladder
The spring-loaded plastic locks must be turned aside on the back of the top roller fitting for hooking-in the ladder. Check the
sliding function, and then place the ladder vertically to the frame or the masonry. The ladder may not be detachable in this
condition. The space required from the top edge of the running track to the lower edge of the ceiling must equal at least
225 cm.
Note regarding the ladder
The ladder is ready to use after checking the stability of the ladder and checking the fastening
points again.
In order to guarantee the safe use of the ladder, certain areas must be checked routinely,
However, at least 1 x per year (see maintenance list).
.
A
TOP
ROLLER
FITTING
BOTTOM CASTOR
Outside of ladder
frame
Ladder frame
Ladder
frame
SLIDING LADDER
G 1102
Page 2 of 2
