3
Electrical TV Lift mechanism TS750
3
Mounting Instruction for the TV Lift
1) Remove all contents from packaging and compare with parts lists. Test the lift
at the same time. Refer to the drawing and to the user instruction packed
along with the remote unit proceed as follows: Connect the lift (#1) to the RF
Module (#3). Once all connections have been made, plug power supply (#2)
into the wall socket. Position lift vertically. Test lift using rocker switch (#4) –
have lift travel a few inches and then back down. Use same method to test
remote. The rocker switch must be pressed continuously to make lift work. Re-
leasing switch will stop unit immediately. The remote starts the lift to move
continuously by one single pres on “up” or “down” button. The lift stops again
by pressing either “up” or “down” button again.
Please see “Helpful Hints” on page 4 before continuing
2) Place the lift unit (#1) on the back panel of cabinet in a location that will allow
full up and down movement of TV. Unit must be a minimum of 1/8” down from
the top edge of the cabinet.
3) Fasten the unit securely to the cabinet using the 7 screw holes shown in the
drawing on page one. Screws must be appropriate for the material being used.
Lift must be mounted vertically (using a level) inside cabinet.
4) Fasten the power bracket (#2) on the back of the cabinet on the right
side of the unit as shown in the drawing. Secure with 2 screws.
5) Fasten R.F. Module (#3) next to the power supply leaving enough room to
connect wires.
6) Mount rocker switch (#4) to the upper part of the cabinet towards the front by
cutting a hole and pressing the switch into place. Secure excess wire to keep
away from moving parts.
7) Make connections as done previously for testing. Plug the power cord into wall
outlet and test the lift. Refer to the connection diagram below:
