3 Mounting hinge and door
Attach hinge mounting plates (F) to slides using (4) M4 x 5 mm
screws. (020.05.210)
Preparing the door
Measure inside height of cabinet.
Cut doors approximately 4 mm (5/32") less than inside height of
cabinet to allow for a 2 mm gap at top and bottom.
Measure distance between centerlines of top and bottom mounting
plates (F) already mounted. Transfer distance to door being sure top
and bottom distances are equal. Determine tab distance from
chart below.
Drill doors using a 35 or 40 mm drill bit.
Install hinges in door using (4) 3.5 x 15 mm raised head countersunk
screws (015.55.639).
Install the door onto the mounting plates.
Close door and check clearances to determine necessary
adjustments.
1
Mounting the slides
Attach slides (A) to side panels using (8) Trusshead screws
(013.03.304) as shown.
Top and bottom locations are determined by pre-mounted
spacer tabs (B). This assumes cabinet is square and parallel.
Make sure slides are absolutely parallel.
Backset is measured from front edge of cabinet to front edge
of rollers:
Inlay doors:
Backset = door thi 1 mm.
Overlay doors:
Backset = 1 mm.
E: Cable Adjuster
D: Set Screw
Trusshead Screws
(B) Pre-mounted Spacer Tabs
(C) Hinge Carrier
Backset
(A) Slides
(F) Mounting plates
Inside Cabinet Height
2 mm Gap top and bottom
Hinge distance
2 Attaching the cables
Slide and lock hinge carriers (C) into forward position.
Uncoil cable and wrap around the rear pulley of the same slide.
Wrap cable on the front pulley of opposing slide.
Lead cable under and around set screw bracket being sure
cable seats in notch.
Wrap cable under set screw washer (D).
Only one wrap is necessary.
Tension cable by hand and tighten set screw irmly.
Cut off any excess cable.
Repeat accordingly for opposing slide.
Door Type
Door Thickness
Tab
Inlay doors
19–32 mm
14 mm
40 mm cup hinge
(3/4"–1 1/4") (9/16")
*Overlay doors
19–22 mm
14 mm
40 mm cup hinge
(3/4"–7/8") (9/16")
Door Type
Door Thickness
Tab
Inlay doors
16–19 mm
8 mm
35 mm cup hinge
(5/8"–3/4") (5/16")
*Maximum overlay - 7 mm (1/4")
2
