2 x Door connecting strips (E)
2 x M6 x 50 mm
Connecting bolt (I)
2 x M6 x 10 mm
Round head bolt (L)
1 x Guide roller (D)
12 x M5 x 6.0 mm
Round head bolt (M)
3 x Brackets (B)
3 x Plate (C)
Tools required (Not Supplied)
Component parts
Height adjustable pull out larder unit:
Assembly guide
Sales and Technical Support -
Tel: 01788 542020, Fax: 01788 544440, E-Mail: [email protected]
Sales and Technical Support -
Tel: 01788 542020, Fax: 01788 544440, E-Mail: [email protected]
•
Make sure all the components are included before
you start.
•
The number for technical support is at the bottom
of the page.
•
Don't rush!
•
Read the instructions first.
•
Assemble in the stages shown.
•
Keep the fittings together to avoid loss.
•
Have fun.
1 x Frame (A)
1 x Runner (F)
500.00-0102
Installed height 950 - 1200 mm = 3 baskets
Installed height 1200 - 1450 mm = 4 baskets
Installed height 1450 - 1700 mm = 4 baskets
Installed height 1700 - 1950 mm = 5 baskets
Installed height 1950 - 2200 mm = 5 baskets
2 x M8 x 40 mm
Round head bolt (J)
36 x M4 x 15 mm
Pan head screw (N)
48 mm pins
x 2 per basket (Q)
2 x M6 x 25 mm
Round head bolt (K)
pin caps
x 2 per pin (R)
8 x M5 x 10.0 mm
Flat head screw (O)
Check off components as shown in diagram and lay on flat surface
1
Basket (H)
Pencil
Bradawl
Spirit Level
Cross Head Screwdriver
Tape measure
Did you know Häfele also supply tools to the trade and industry?
See www.hafele.co.uk for more information.
SW4 Allen key
FITT-10057
Issue - 01
3
Threaded hole bracket
Flat head screw
Working outside the carcase, secure the two part frame together by
inserting one of the four connector strips into the bottom section of
the frame and align the holes. BE CAREFUL NOT TO LET THE CONNECTORS
SLIP DOWN INSIDE THE MAIN FRAME! Insert the one of the eight M5 x 10mm
screws. Repeat this procedure for the other three frame connectors as shown
in the drawing making sure the cut outs in the frame are on the same side top and
bottom, Slide the top section of the frame over the secured connectors
aligning the holes and secure using the remaining four M5 x 10mm screws.
Make sure the screws are securely tightened before proceeding.
4 x Frame
connectors (G)
