3
INSTALLATION INSTRUCTIONS
WARNING: THIS APPLIANCE MUST BE EARTHED
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 1 Instruction Manual
• Before connecting the refrigerator to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.
To level your refrigerator, adjust the leveling leg at the bottom of the refrigerator.
• Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air circulation
to cool the compressor.
• Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the refrigerator not to perform properly.
• Avoid locating the refrigerator in moist areas.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food
in the refrigerator compartment.
Before Using Your Refrigerator
Installing Your Refrigerator
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug
which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with three-prong ground. Have the
wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a
standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a
properly grounded 3-prong wall outlet.
The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating that
matches the rating label on the appliance. This provides the best performance and also prevent overloading
house wiring circuits that could cause a fire hazard from overheated. Never unplug the unit by pulling the power
cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all
power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion
damage along its length or at either end. When moving the unit, be careful not to damage the power cord.
WARNING!
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
Electrical Connection
INSTALLATION INSTRUCTIONS
