Hafco PN1/2-2, Руководство по эксплуатации

Страница: 5 / 12

5
OPERATION MANUAL
1. This precision Pipe/Tube Notcher is a useful fixture for your drill press, allowing you to make
round cuts in pipes and tubing of various shapes at any angle from 0° to 45° .
2. Sturdy and durable steel frame holds your workpieces rigid during operation.
3. Adjustable Angle Joint Plate (17#) is adaptable to any worktable, and is especially suited to
be mounted on a drill press.
4. The Adjustable Angle Joint Plate (17#) may be swiveled and rotated, which in conjunction
with the adjustable holder makes cutting compound angles very easy.
5. Works with any standard drill press, and is adaptable to use a large variety of round cutters,
hole saws, and milling bits.
WARNING: When using this Pipe/Tube Notcher with any powered tool, observe all safety
precautions relevant to that equipment. Refer to the owner’s manual of the power equipment
for safe practices in the use of attachments.
UNPACKING
This machine was carefully packaged for safe transport. When unpacking, separate all enclosed
items from packaging materials and inspect them for shipping damage. If items are damaged,
please contact your distributor.
NOTE: Save all the packaging materials until you are completely satisfied with the machine and
have resolved any issues with the distributor, or the shipping agent.
ASSEMBLY
1. The Spindle (7#) is shipped in the reverse position. Remove it and re-insert it in the correct
position prior to using the tool.
2. Your Pipe/Tube Notcher must be mounted to your drill press table, using the adjustable
angle joint plate (17#) Depending on the configuration of your drill press table, you may use
T-bolts, carriage bolts, or machine bolts, washers and nuts. (Hardware not supplied.)
3. After mounting, be sure that the Spindle (7#) travels smoothly without binding against the
Bushings (5#). Any undue friction will cause excessive wear of the Bushings (5#).
4. The angle of the Pipe/Tube Notcher can be adjusted by loosening the Bolts (16#) that adjust
the Adjustable Angle Joint Plate (17#), and moving the Assembly as necessary.
5. For side to side adjustments, adjust the Bolts (15#) that hold the Adjustable Angle Joint
Plate (17#) to the Body (13#).
6. When installing the hole saw, check first to see if its arbor is 1/2” or 5/8”. The thread on the
spindle is for 1/2”, however, there is a Hole Saw Adapter (3#) for 5/8” thread that can be
screwed on over the 1/2” thread. You may need to use the Hole Saw Adapter Washer (4#) to
assure a good, secure fit.
7. To install a saw blade or bit, first fix the Spindle (7#) in place with the Locking Pin (14#). Do
not use locking pliers or clamps to hold the Spindle (7#), as this will cause damage. Slide the
Locking Pin (14#) through the hole in the side of the Spindle Support (6#) and through the
Spindle (7#). Install the blade, then remove the Locking Pin (14#).
WARNING:
Make sure the Locking Pin (14#) is removed prior to engaging the drill.
FEATURES