M
-
16 Chisel Mortiser
V.02 01-11-2010
３
ADDITIONAL SAFETY RULES FOR CHISEL
MORTISERS
1.
DO NOT OPERATE THIS MACHINE
until it is
assembled
and
installed
according to the instructions.
2.
OBTAIN ADVICE FROM YOUR SUPERVISOR, instructor, or another qualified person
if you are
not familiar with the operation of this machine.
3.
FOLLOW ALL WIRING CODES
and recommended electrical connections.
4.
MAKE CERTAIN
the machine is fastened to a supporting surface to prevent it from tipping over
during operation.
5.
NEVER
turn the mortiser
“
ON
”
before clearing the table of all objects (tools, scrap pieces, etc.).
6.
ALWAYS
keep hands, fingers and hair away from the rotating bit.
7.
DO NOT
attempt to mortise material that does not have a flat surface, unless a suitable support is
used.
8.
ALWAYS
position holddown directly over workpiece to prevent workpiece from lifting during
operation.
9.
ALWAYS
support workpiece securely against fence to prevent rotation.
10.
BE SURE
drill bit is sharp, not damaged, and properly secured in the chuck before operation.
11.
MAKE SURE
chuck key is removed before starting machine.
12.
NEVER
turn on the power with the drill bit or chisel contacting the workpiece.
13.
NEVER
perform layout, assembly, or set-up work on the table while the mortiser is operating.
14.
ADJUST
the depth stop to avoid drilling into the table.
15.
ALWAYS
turn off the power before removing scrap pieces from the table.
16.
SHUT-OFF
the power, remove the drill bit and chisel, and clean the table before leaving the machine.
17.
FOR YOUR OWN SAFETY
–
Don
't
wear gloves when operating the machine.
18.
SHOULD
any part of your tool be missing, damaged, or fail in any way, or any electrical component
fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing,
damaged, or failed parts before resuming operation.
19.
THE USE
of attachments and accessories not recommended by Delta may result in the risk of
injuries.
20.
TURN THE MACHINE
“
OFF
”
AND DISCONNECT THE MACHINE
from the power source before
installing or removing accessories, before adjusting or changing set-ups, or when making repairs.
21.
TURN THE MACHINE
“
OFF
”
,
disconnect the machine from the power source, and clean the
table/
work area before leaving the machine. LOCK THE SWITCH IN THE
“
OFF
”
POSITION to
prevent
unauthorized use.
Page 5
Instructions Manual for M-16 (W347)
07/06/2017
