Hafco HM-32, Руководство по эксплуатации

Страница: 26 / 27

Lathe-Mill-Drill Safety Instructions
1. Maintenance.
Make sure the Lathe-Mill-Drill is
turned off and disconnect from the main power
supply and make sure all moving parts have come to
a complete stop before any inspection, adjustment
or maintenance is carried out.
2. Lathe-Mill-Drill Mill Drill Condition.
Lathe-Mill-Drill
must be maintained for a proper working condition.
Never operate a Lathe-Mill-Drill that has damaged or
worn parts. Scheduled routine maintenance should
performed on a scheduled basis.
3. Leaving a Lathe-Mill-Drill Unattended.
Always
shut the Lathe-Mill-Drill off and make sure all moving
parts have come to a complete stop before leaving
the Lathe-Mill-Drill. An unsupervised running Lathe-
Mill-Drill can cause serious injury.
4. Avoiding Entanglement.
Remove loose clothing,
belts, or jewelry items. Tie up long hair and use the
correct hair nets to avoid any entanglement with
moving parts.
5. Chuck key safety.
Never let go of a chuck key while
still in the chuck to prevent leaving the chuck key in
the chuck. Chuck keys left in the chuck can cause
serious injury.
6. Understand the machines controls.
Make sure you
understand the use and operation of all controls.
7. Tooling selection.
Always use the correct cutting
tool for the job you are turning. Make sure it is sharp
and held firmly in the tool post. Adjust the toolpost to
provide proper support for the tool you will be using.
8. Tooling selection & holding.
Always use the
correct cutting tool for the job you are milling. Make
sure it is sharp and held firmly in place.
9. Cutting Tool inspection.
Inspect Drill and end mills
for sharpness, chips, or cracks before use. Replace
any cutting tools immediately if dull, chipped or
cracked. Handle new cutting tools with care. Cutting
edges are very sharp and can cause lacerations.
10. Reversing the spindle.
Make sure the spindle
has come to a complete stop before changing the
direction of the spindle. Do not slow or stop the
spindle by using you hand.
11. Stopping the spindle.
Do not slow or stop the
spindle by using you hand.
12. Mounting the workpiece.
Make sure the
workpiece is properly mounted and secure before
turning on the Lathe-Mill-Drill. A loose workpiece
can be thrown across the room and cause serious
injury to you or a bystander.
13. Workpiece clearance.
Rotate the workpiece by
hand to check for clearance with the tool post,
compound slide and carriage before turning the
Lathe-Mill-Drill on.
14. Changing speeds and Reversing.
Turn the Lathe-
Mill-Drill off and make sure the Lathe-Mill-Drill has
come to a complete stop before changing speeds
or reversing the spindle. Do not slow or stop the
Lathe-Mill-Drill chuck by using you hand.
15. Speed selection.
Select the appropriate speed for
the type of work, material, and tool bit. Allow the
Lathe-Mill-Drill to reach full speed before beginning
a cut.
16. Clearing chips.
Always use a brush to clear chips.
Never clear chips when the Lathe-Mill-Drill is
running.
17. Power outage.
In the event of a power failure
during use of the Lathe-Mill-Drill, turn off all
switches to avoid possible sudden start up once
power is restored.
18. Clean work area.
Keep the area around the Lathe-
Mill-Drill clean from oil, tools and chips.
19. Call for help.
If at any time you experience
difficulties, stop the machine and call you nearest
branch service department for help.
Machinery House
requires you to read this entire Manual before using this machine.
Page 26 Instructions Manual for HM-32 (K012) 07/02/2018