Hafco Woodmaster W4346, Инструкция по эксплуатации

Страница: 12 / 32

MITER GAUGE ADJUSTMENT
1. Place the miter gauge in the table slot.
2. Loosen the clamp screw on the miter gauge.
3. Adjust the desired angle of cutting on the miter
gauge.
4. Tighten the clamp screw. (see Figure 16)
SAFETY DEVICE
1. Limit switch (see Figure 17) inside the machine
body for cutting off the power while door
opening during operation.
2. Added door lock (see Figure 18) to link upper
and lower doors in between. To prevent the
door being suddenly opened during operation.
REMINDER
Once completing assembly, please test run the machine to ensure it is properly connected to power
and safety components are functioning correctly.
If you find an unusual problem during the test run, please stop the machine immediately. Disconnect
the machine from power and fix the problem before operating the machine again.
Figure 16
Figure 17
Figure 18
9
04/11/2019 Instructions Manual for BP-480 (W4346) 12