Hafco Woodmaster SB-12, Руководство оператора

Страница: 10 / 18

10
Remove the table insert.
Assemble the blade guard assembly with two M6X10 hex bolts and 6mm flat washers. Align the riving
knife with the blade and tighten the bolts.
After all these steps, the machine
’
s assembly is finished.
Operation
Prepare the workplace where the machine is to be placed. Insure sufficient room to allow safe work
without interference. The machine is designed to operate in closed rooms.
Important: The machine must only be brought into service complete with protection devices.
Before switching on the machine, all safety and protection devices have to be installed according to the
instructions.
Always check timber, which has been processed before, for foreign objects (nails, screws, etc.). Remove
all foreign matter.
Before turning on the power supply, make sure that the saw blade is installed correctly and that all
moving components can move freely.
Warning: If in doubt, have the machine set by a qualified person. It is too dangerous to work on
assumptions.
Saw Blade
–
Diagonal Adjustment
The saw blade may be swiveled from 90
°
to 45
°
by turning the hand wheel after the locking knob has
been loosened.
Check the 90
°
and the 45
°
position before the first and each subsequent startup.
Saw Blade Height Adjustment
The saw blade is adjustable from 0 to 100 mm cutting height
For safe and clean working, choose the minimal saw blade projection for the work piece.
M6X10 hex bolts and
6mm flat washers
M6X10 hex bolts and
6mm flat washers