Hafco Woodmaster BP-430A, Руководство по эксплуатации

Страница: 20 / 49

20
OPERATION MANUAL
5.3 CHANGING THE BLADE
To remove the blade:
1. DISCONNECT POWER FROM THE BAND SAW
2. Release the blade tension by turning the blade
tension hand wheel (Fig. 5.8) or turn the quick release
lever to the left.(Fig. 5.9)
4. Remove the table insert and the table pin. Adjust the
upper and lower guide bearings as far away as
possible from the blade.
5. Open the upper and lower wheel covers, (Fig. 5.10)
Put on leather gloves and slide the blade off both
wheels.
6. Rotate the blade 90˚ and slide it through the slot in
the table.
7. Take the new blade and slide it through the table
slot, ensuring that the teeth are pointing down
toward the table.
NOTE: If the teeth will not point downward in any
orientation, the blade is inside-out. Put on leather
gloves, and remove the blade, and twist it right side-out.
8. Slip the blade through the guides, and mount it on
the upper and lower wheels.
9. Tighten the blade tension quick release.
10. Apply tension to the blade by turning the tension
control knob. Rotate the upper wheel slowly by hand
as tension is applied to allow the blade to centre
itself on the wheel. Adjust tracking if needed.
11. Adjust tension as described Page 15.
12.Adjust the upper/lower guide bearings and the
support bearings.
13. Close the wheel covers.
14.Replace the table insert and table pin, being sure not
to use excessive force when inserting the table pin.
All saw blades are dangerous
and may cause personal injury. To reduce the risk of
being injured, wear leather gloves when handling saw
blades.
F
ig
. 5.8
F
ig
. 5.9
F
ig
. 5.10