Hafco Metalmaster HM-53GV, Руководство по эксплуатации

Страница: 8 / 54

7
and turning the spring to different position. The spindle sleeve clamping handle
⑥
should be clamped for milling. To obtain the best effect, pls choose the 3-blade
vertical milling tool, the most, the working table must be hoisted to the nearest
position to the spindle when the 2-blade milling tool is used.
6. The boring function can be realized after equipping relative accessories. It is
better to apply to micro-feeding during milling and boring.
7. The spindle box can turn
±
90
°
in vertical plane for turning the spindle box,
pls firstly loosen the three tighting nut connecting with spindle box, turn the spindle
to the needed angle through turning micro-worm
⑧
, finally pls tight the nut.
8. The cross-slide of spindle box can be realized through the ram moving for
cross-sliding, pls firstly loosen the two clamping bolts
⑨
locating on the right side of
the ram, turn the gear shaft
⑩
, to move the ram and spindle box, and tight the two
clamping bolts.
9. The spindle box can turn 360
°
around the column in the horizontal plane. To
realize this, pls firstly loosen the 4 pcs of clamping nuts
⑾
under the ram, turn the
ram to the suitable position, finally tight the 4 pcs of clamping nuts.
10. The spindle's turn and revolve can be realized by the switch located in the
right side of hoist-descend sliding.
11.
The horizontal milling can be realized by turn the vertical spindle box 90
°
.
The spindle box must turn 180
°
when the tool shaft and jack applied for assistance.
12.
If the machine doesn't work well or have irregular noise, pls immediately shut
off machine.