P/N 53063-30, Manual revision: B
5-2
Cell Saving using Automatic Operation
P
ERFORMING
A
PROCEDURE
IN
THE
AUTOMATIC
MODE
This chapter will explain how to operate the CS5+ device in the AUTOMAT-
IC mode to perform cell salvage. The descriptions are applicable to all of the
bowl types – the Latham bowls (225 ml and 125 ml) as well as the 70mL
Bowl, unless specifically indicated otherwise in the text.
Examples of the screen displays which the operator will encounter during
operation will use default settings and values possible with the Latham 225
ml bowl. Reference tables which list the default settings according to the dif-
ferent types of bowls are provided in the section
Prior to processing any blood, the disposable set must installed as explained
in
. Because of the controls and “intelligence” built into the
CS5+ device, automatic processing will produce consistently good results
when the solutions have been properly prepared and the disposable set has
been correctly installed.
Note: Anticoagulant solution administration is not regulated by the CS5+
device and should be done manually or by another device. The recom-
mended AC solution is 30,000 units of heparin in 1 liter of normal saline
solution. The drip rate should be set during the procedure at 1-2 drops per
second depending on the rate of blood flow being processed.
Explaining the STANDBY state
Once the CS5+ device has been powered on and the system self-test has
been successfully completed, the following information will be displayed:
Figure 5-1, Example of a STANDBY state screen display (initial)
E
K,-?5&8#5-
$2I+
M
2F:NC
M
O(8*#T,-?5&P
M
Q,7-8#'%,.&88&3P
M
$%&88#ADE2D#),#V/--#6,7-"
$%&88#JIR:CS#),#.*(0=&#'(%(5&)&%8"
$%&88#SFA#),#%&8&)#5,3/V4#'(%(5&)&%8"
N&&3#LMM#5-#/0#%&8&%T,/%
),#C:GG#(?),5()/.(--4
ADENRQS