Haemonetics BloodTrack Kiosk V5, Руководство по установке

Страница: 62 / 81

BloodTrack Kiosk® V5 Installation Guide
HAE: SM-BloodTrack-08(AA) SBC100xxx
GBE: 2000-JNB0012 50
The BloodTrack Kiosk V5 has an emergency access switch that can be used to
interrupt the Relay Common (RC) connection and unlock the door to the storage
location.
The switch is recessed to prevent accidentally triggering the emergency access to
the storage location and requires use of a tool to be activated, such as a pencil, pen
or stylus.
The switch is a latched toggle type and will remain in the on or off state until it is
manipulated again.
To open the door to storage locations controlled by the BloodTrack Kiosk V5:
1. Obtain a suitable probe or pen/pencil to fit the switch hole.
2. Insert the tool in to the emergency access switch hole and push upwards until
the switch clicks
—and then remove the tool. The doors controlled by the
BloodTrack Kiosk V5 will unlock.
Note:
Activating the emergency access switch on the BloodTrack Kiosk V5 will invoke
the emergency access procedure within the BloodTrack Courier
®
software.
A - Reset Button B - Engineer USB port
C - Emergency Access Switch D - Barcode Reader
Figure 21 Emergency access switch location
Note:
The switch will remain in the emergency access position until repositioned.
3. Remove only the units needed.
4. Close the door to the storage location.
A
B
C D