Haemonetics BloodTrack Kiosk V5, Руководство по установке

Страница: 40 / 81

BloodTrack Kiosk® V5 Installation Guide
HAE: SM-BloodTrack-08(AA) SBC100xxx
GBE: 2000-JNB0012 28
4.2 Unpacking the BloodTrack Kiosk V5 and Parts
CAUTIONS
•
Only Haemonetics-approved service personnel are authorized to handle the
BloodTrack Kiosk V5 during installation and commissioning.
•
Lay the equipment on a reliable flat surface before, and during, the setup
process.
Upon receipt of the BloodTrack Kiosk V5, inspect the shipping container(s) and note
any signs of damage. Then unpack the container(s) and carefully inspect for
damage to the contents. If the equipment has been damaged in transit, immediately
report the extent of damage to the transportation company and to Haemonetics
Technical Support.
Before mounting the BloodTrack Kiosk V5, verify that all parts have been received
—
see Section 4.2.1
—List of Parts
. If there are any items missing or damaged, contact
Haemonetics Technical Support for replacement parts
—see
Appendix C
—Product
Support .
4.2.1 List of Parts for the BloodTrack Kiosk V5
Confirm the following parts have been received:
•
BloodTrack Kiosk V5
•
Active shelf chassis and cover, three M4 x 10mm screws and mushroom-lock
tabs
•
Latching power cable cordset
•
UPS (including latching IEC extension lead)
—optional
•
Shielded CAT5e Ethernet cable (length: 6.6 ft.
— 2 m)
•
Data port protective guard, three M3 x 10mm screws
•
Wall mount system: wall bracket, kiosk bracket, eight M4 x 10 screws
•
Desk stand mount with screws
—optional
•
Electromagnetic locks and brackets (including detailed installation
instructions)
—optional.
4.3 Operating the BloodTrack Kiosk V5
The BloodTrack Kiosk V5 is set to automatically start when mains power is applied.
It will automatically load the BloodTrack Courier Solution, ready for use. Use of the
BloodTrack Kiosk V5 varies from site-to-site and department location; however, a
maximum frequency of use will be approximately once every 60-90 seconds, but
can be as low as once a week.