HAEGERTEC New Tornado, Инструкция пользователя

Страница: 5 / 24

English
Instructions for use 3
Assembly instructions
The device must be completely assembled before use!
1. Mount the fan onto the supporting base (3) by having its two pivots protrude
through the two holes on the supporting base (see the Fig. 2).
2. Use the plastic ring spanner (attached to each fan) to turn clockwise the
two nuts onto the pivots closely (see Fig. 3).
3. Attach the front guard to the rearguard by locking the clips.
NOTE : When installing the switch box, make sure the electrical wires are located
on the outside of the base.
Position
The ideal position is a non-slip, flat surface.
Do not place the device immediately next to stoves or other sources of heat.
Putting into Service
Electrical Connection
1. Connect the device to a duly installed 220-240V~50/60Hz protective contact
socket.
2. Before inserting the plug into the socket. Make sure that the mains voltage
to be used matches that of the device. You can find this information on the
nameplate.
Use
Blower direction
Set the blower inclination angle before starting the device. You can adjust the
inclination angle by tipping the blower casing with both hands. Caution! The
inclination angle amounts to approx. 90°.
Operating
To select the fan speed, use the selector on the switch box to set one of the
following speeds:
0 = OFF, 1 = Slow, 2 = Medium, 3 = Fast/Turbo.