English
4
Instructions for use
Making Ice cubes
1.
Open the lid and remove the ice cube container.
2.
Fill the water tank with potable water (tap water) to the MAX marking.
Notes:
•
Make sure the water level in the water reservoir is not over the ice collecting tray.
•
Only use water at room temperature.
3.
Replace the ice cube container and close the lid.
4.
Select desired ice cube size by pressing
SELECT
button.
Note:
Please select the small ice cube size when ambient temperature is below 15°c. When the
ambient temperature is higher than 30°C, large ice cube sizes are recommended.
5.
Press
START
to start the ice cube production. The process takes between 9 and 13 minutes.
6.
Keep the lid closed.
Note:
For the first three cycles, the ice may be small and irregular in size.
7.
If the indicator light
ADD WATER
is turned on, the ice cube production is automatically halted. Take
out the ice cube container and refill with potable water the water tank. Press
STOP
and then
START
button to restart the Ice maker.
8.
If indicator
ICE FULL
is turned on, please take out the ice cubes with the scoop. Press
STOP
and then
START
button to restart the ice maker.
Notes:
•
If no water is pumped up to the water tray over two cycles but the water in water tank is enough,
then opens the drain cap and let several drops water runs out.
•
When the ice collecting tray is full please remove the ice immediately, Do not allow the ice
collecting tray to overfill.
Cleaning and Maintenance
Always unplug the appliance from the power socket before performing any cleaning or maintenance
operations.
-
Clean the appliance using a damp cloth then dry with a dry cloth.
-
Do not use harsh or abrasive cleaning agents.
-
Do not use petrol, alcohol or solvents to clean the appliance.
-
Do not submerge the appliance in water.
-
Remove the ice cube container and clean it with a mild detergent under running warm water.
-
Clean casing and interior with a damp cloth.
-
Use a diluted solution of vinegar and water.
Drain residual water
Drain the residual water if the appliance is not in use for a longer period.
–
To drain the residual water, remove the drain cap.
–
After the residual water has been drained, screw the drain plug back in place.
