Anleitung / Manual Hacker A10 Brushless Motor
© 2016 Hacker Motor GmbH
Seite 6
vermieden werden.
Eine zu hohe Wärmeentwicklung tritt dann auf, wenn der Motor überlastet wird. Dies kann z.B.
durch eine zu große Luftschraube, durch ein Blockieren der Motorwelle oder durch zu lang
andauernde Einschaltdauer geschehen. Deshalb ist im Zweifelsfall immer zuerst eine kleinere
Luftschraube zu erproben und dabei die Motortemperatur zu prüfen.
Es ist immer für eine wirkungsvolle Kühlung zu sorgen.
Den Motor keinesfalls im Leerlauf ohne Last betreiben! Der Motor kann auch durch nur kurzzeitige
sehr hohe Drehzahlen zerstört werden.
The A10 motor can be used for front and back-mount. To attach it in front of the firewall the included
adapter can be applied to the motor. Therefor use four countersunk head screws included in the set.
Install the propeller adapter with the screws to the bell. Then bolt the motor with the screws on the
firewall of your model. Make sure the motor is well attached and cannot get loose during operation.
To mount the motor behind the firewall use all four screws. Make sure the motor is well attached and
cannot get loose during operation. Be careful not to exceed the recommendations for screw
protrusion into the motor’s case.
Maximum screw depth: 3 mm
The included plywood plate should be used as drill pattern only. It is not eligible for mounting the
motor.
Excessively high temperatures will destroy an electric motor. Hacker Brushless Motors are designed
for operating temperatures of the housing up to 65°C (149°F). Temperatures exceeding this value can
lead to motor damage and should be avoided.
Excessive temperatures result from overloading the motor and may arise from using a too large
propeller, an obstructed or jammed motor shaft, or excessively long motor startup times. Therefore it
is better to be safe beginning with a smaller propeller and check the motors temperature. Effective
cooling must always be ensured.
Do not run the motor without an adequate load. The motor can be quickly destroyed by excessively
high RPM and free running!
