2
3
1-2
1-1
1-6 (C)
1-5 (B)
1-4 (A)
1-3
1-12
1-12
1-12
K I T 1 : T H E U P P E R J A W
2
1
EXPERT TIP:
If the screws
are difficult to fit, it could be
because they are cutting a thread
as they are being screwed in. If this
should be the case, try turning the
screw forwards half a turn, then
back a quarter of a turn. Repeat
this process until the screw is
firmly secured in place.
To begin the assembly, place the Skull
1-1
upside down on the work surface.
Orientate the Upper Jaw A
1-2
so that
the three screw holes align with the
clear raised sockets on Skull part
1-1
.
Using the Screwdriver
1-11
, or similar,
fix the two parts together with three
2x6mm
1-12
screws. Ensure the parts
fit snugly together and the screws are
fully seated.
Place the Upper Jaw B
1-3
on a flat
surface with the teeth sockets facing
upwards. The teeth are individually
embossed with a letter to help
identify them. The Teeth
1-4 (A)
,
1-5 (B)
and
1-6 (C)
are fitted into
their corresponding sockets on the
right hand side, as shown. Test-fit
the teeth, noting how the sockets
are individually shaped. When you
are happy with the fit, apply a small
amount of superglue in their sockets
and secure the teeth firmly in place. A
cocktail stick or similar is useful when
applying small amounts of glue.
