Hach Sigma 900 MAX, Руководство пользователя

Страница: 30 / 122

30
Installation
4.3.1 Attaching the intake line
Note: If attaching Teflon
®
lined tubing using Teflon lined connection kit (2186), refer to the
instructions supplied with the kit.
Attaching the vinyl tubing
The connection kit (2248) contains two identical assemblies, one for connecting vinyl
tubing to the sampler pump, and the other for connecting the vinyl tubing to an intake
strainer. The kit contains four hose clamps and two stainless steel tubing connectors.
1. Push one end of the tubing connector into the vinyl tubing attached to the controller
until the tubing abuts the shoulder of the tubing connector. Secure with a tubing
clamp (
Figure 12 ).
2. Push the other end of the tubing connector into the vinyl tubing until the tubing abuts
the shoulder of the tubing connector and secure with a tubing clamp (
Figure 12 ).
3. Repeat Step 1 and Step 2 for the fitting that connects the vinyl tubing to an intake
strainer.
Attaching the Teflon
®
-lined tubing
The Connection Kit for Teflon-lined Tubing (2186) contains two identical assemblies, one
for connecting the Teflon-lined tubing to the stainless steel tubing connector and the other
for connecting the Teflon-lined tubing to the intake strainer. The kit contains six clamps,
two lengths of silicone tubing, and two stainless steel barbed fittings.
To connect the Teflon-lined tubing, refer to the instruction sheet supplied with the
Teflon-lined tubing connection kit.
Figure 12
3
/
8
” Vinyl tubing connector
1 Vinyl tubing to controller 3 Tubing clamp (2 required)
2 Vinyl tubing to strainer or pump 4 Stainless steel tubing connector
Goodnal STP ST041 Pre Treatment (Sigma 900 MAX All Weather Refrigerated Sampler) Vendor Manual
Q-Pulse Id VM373 Active 29/10/2013
Page 30 of 122